The direction can be switched by right-clicking the connection point.
It is not affected by Bearing rotation or Piston length settings. Increasing the speed setting lowers the time it takes for the Controller to complete each frame.įrame time is constant and is based on the speed setting of the Controller. When loop mode is not enabled, sending a signal to a Controller will cause it to stop at the last frame, and taking away the signal will cause the sequence to run in reverse until the starting position is reached.ĥ. Loop: Enabling loop mode will cause the Controller to repeat the sequence after reaching the last adjusted frame. Bearing rotation settings are adjusted by 15 degrees at a time single degree adjustments can be made by holding Shift.Ĥ. The setting at each frame (#2 and #3) can be edited by clicking and dragging to the left or right.When a signal is sent to the Controller, it will move through the programmed sequence from left to right.
Frames 1-10: Set the amounts by which Bearings will be rotated, in degrees, and the total lengths that Pistons will extend. Frame 0: The starting position of the Bearing or Piston (before a signal is sent to the Controller).ģ.
This number is indicated on the connection point of the Bearing or Piston.Ģ. Connection Order Number: This number corresponds to a Bearing or Piston that is connected to the Controller.
0 kommentar(er)
